Full ECU Tool EFSO
by ecu-file-service-online.com
Efter mærke
Efter ECU
Efter familie
🔧 Clonage ECU
Bestil min fil
Accueil
›
Fabricants ECU
›
Bosch
›
MG1CS003
Bosch MG1CS003
Spécifications complètes du calculateur
🏷️ Haute sécurité
🚦 Niveau Expert
✓ Fiabilité moyenne-élevée (varie selon SOTA)
Kloning af denne styreenhed
⛔
Kan ikke klones
Cet ECU n'est pas clonable selon la source actuelle.
Niveau de risque
Élevé
Microcontrôleur (indication publique)
AURIX TC2xx/TC3xx selon HW exact
Source :
Magicmotorsport Flex 2026-05-22
— données reproductibles à confirmer par hardware/software.
Tekniske specifikationer
Producent
Bosch
Modèle ECU
MG1CS003
Familie
Bosch MG1
Udstyrede køretøjer
2
Catégorie
modern high security
Stage 1 (gains)
diesel/gasoline typical +15-30%; sourced dyno required per vehicle
Stage 1 (prix indicatif)
€250-€650 retail / €40-€120 file service
Temps d'intervention
20-90 depending virtual read, bench unlock, checksum
Niveau requis
workshop only recommended
Outils nécessaires
professional flasher + stabilised PSU + bench cable where needed + checksum support
Fiabilité
medium-high when supported, lower on new SW/SOTA locked variants
Architecture
Bosch MG1/MD1 modern bootloader class
Mikrokontroller (MCU)
Aurix TC2xx/TC3xx family
Mémoire / Flash
internal flash + emulated/internal eeprom by variant
Lecture / écriture possible
varies: connector BSM may avoid opening on supported old protection
Sécurité / protection
possible old/new protection split; possible SOTA/dual-bank on TC387/TC399 variants
Cadre légal
FR/DE/CH/EU: road use may be illegal if emissions/noise/type-approval affected; track/export disclaimer required; verify local law
🏷️ Mærker kompatible med denne styreenhed (1)
Opel
1
Udstyrede køretøjer
Opel Combo (E)
Bosch MG1CS003 omprogrammering inden for 24t
Stage 1, DPF OFF, EGR OFF, IMMO OFF — Spécialiste ECU Bosch
Bestil min fil